Check cabling & retest. Re-test Drive 145 FULL STROKE ERROR Error encountered during full stroke seek. Fair to say the drive is probably u/s, but can't find any real info on exactly what the error is. This may be due to a defect with the drive or the drive may not have responded properly due to a bad connection. weblink
Please re-test the drive with Data Lifeguard. Further errors indicate a defective drive. Replace the drive if the error repeats. Retest after checking the connections. http://www.techsupportforum.com/forums/f16/solved-what-is-error-status-code-0132-from-data-lifeguard-diagnostics-537960.html
Drive should be replaced. Some vendors use the security feature to ensure the usage of only specific drives in their system, or the drive may have been locked by a user using a third party Drive Reliability Monitor. Please ensure that you are using the proper version of diagnostic utility.
Virtual Memory Too Low Another problem that we always experience is connected to the RAM space of our PC. No Errors 101 Unknown Error An unknown error has occurred during testing. Re-Test Drive 106 Track 0 Error Track 0 was not properly detected. Dell Validation Code It said : Windows could not start because of a computer disk hardware configuration problem.
At least ten ECC errors have been detected. Self-Monitoring, Analysis, and Reporting Technology (SMART). Create and use a new DLG Tools diskette. news LOL.
Replace Drive 215 2-9 IDNF Errors Identified Data Not Found (IDNF) 2-9. Dell Error Code 2000-0131 It also may be due to a defective connection. If the drive were installed new, and errors are indicated, it may be that the BIOS isn't up to date as far as the drive's cylinder count status. would this work?
Small imperfections and pits in the CPU wafer allow tiny gaps that reduce the effectiveness of the heat sink. http://www.motherboards.org/forums/viewtopic.php?t=104651 Re-Test Drive 102 Seek Timeout A Seek command did not complete in the time allotted for its completion. Dell Error Code 2000-0132 However, if the client is not able to reestablish the connection after several attempts, then this error message is thrown.. Dell Battery Error Code 2000-0132 Ten or more instances of track information could not be found.
Answered! have a peek at these guys Retest after checking the connections. Retest. Moderator: The Mod Squad Post a reply 7 posts • Page 1 of 1 Reply with quote Western digital hdd command error 0132 by sylvester » Fri Feb 08, 2008 12:26 Dell Epsa Error Codes List
Retest after checking the connections. For that you need to use a professional service, unless you have the proper equipment available. It may also be due to a defective connection. http://powerproxy.net/error-code/dell-error-code-0333.html An onboard defect counter has determined the drive has too many errors and should be replaced.
Non-WD drives are not supported. Dell Support This may be an anomaly or a defect with the drive. Continue to test or exit the test.
Replace the drive. This error may have internal and external reasons. Replace the drive if the repair fails. But I would wait until this get confirmed or not by someone more experienced.
to report if a drive has failed, it must be enabled as a system option. One possible cause for this is the attack of virus. Retest the drive. http://powerproxy.net/error-code/how-to-fix-error-code-0146-dell-inspiron.html Extra screws and washers will not do this effectively.
My Operating system is Xp Home Edition SP3 (Legal copy) On the board it has these numbers : 2060-701314-003 REV A On the sticker it has these numbers : 2061-701314-A00 AP Re-test Drive 134 Busy Timeout Timeout from checking busy bit.